Toro Reelmaster 7000-D Operator's Manual page 26

Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
Note:
Rotate the key switch to the O
then to the O position locks the protected menu.
N
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to Protect Settings option. Use the
right button to change the setting. Setting the Protect
Settings to O allows you to view and change the
FF
settings in the Protected Menu without entering the
PIN code. Setting the Protect Settings to O
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch O
and back to the O position to enable and save this
N
feature.
Setting the Auto Idle
1. In the Settings Menu, scroll down to Auto Idle.
2. Press the right button to change the auto idle
time between Off, 8S, 10S, 15S, 20S, and 30S.
Setting the Blade Count
1. In the Settings Menu, scroll down to Blade Count
2. Press the right button to change the blade count
between 5, 8, or 11 blades.
Setting the Mow Speed
1. In the Settings Menu, scroll down to Mow Speed.
2. Press the right button to select mow speed.
3. Use the center and right button to select the
appropriate mow speed set on the mechanical
mow-speed limiter on the traction pedal.
4. Press the left button to exit mow speed and save
the setting.
Setting the Height of Cut (HOC)
1. In the Settings Menu, scroll down to HOC.
2. Press the right button to select HOC.
3. Use the center and right button to select the
appropriate HOC setting.
Note:
If the exact setting is not displayed, select
the nearest HOC setting from the list displayed.
4. Press the left button to exit HOC and save the
setting.
Setting the Front and Rear Reel
Speeds
Although the front and rear reel speeds are calculated
by inputting the number of blades, mow speed and
HOC into the InfoCenter, you can manually change the
setting to accommodate different mowing conditions.
position and
FF
1.
2.
hides the
N
FF
26
Scroll down to the F Reel RPM, R Reel RPM,
or both.
Press the right button to change the reel speed
value. As the speed setting is changed, the
display will continue to show the calculated reel
speed based on blade count, mow speed, and
HOC which was previously entered, but the new
value will also be displayed.