Toro Reelmaster 7000-D Operator's Manual page 14

4. Assemble and adjust as described in the cutting
unit Operator's Manual.
5. Make sure that the counter weight
installed to the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
Figure 9
1. Counter weight
6. All of the cutting units are shipped with the turf
compensation spring mounted to the right side
of the cutting unit. The turf compensation spring
must be mounted to the same side of the cutting
unit as the reel drive motor. Reposition the turf
compensation as follows:
A. Remove the 2 carriage bolts and nuts
securing the rod bracket to the cutting-unit
tabs (Figure 10).
Figure 10
1. Turf compensation spring
2. Rod bracket
B. Remove the flange nut securing the
spring-tube bolt to the carrier-frame tab
(Figure 10)
C. Remove the assembly.
D. Mount the spring-tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut.
(Figure 9) is
g003320
g003949
3. Spring tube
Note:
Position the bolt head to the outer
side of the tab as shown in
1. Opposite carrier frame tab
E. Mount the rod bracket to the cutting unit
tabs with the carriage bolts and nuts
11). On the cutting unit, mount the left hose
guide to the front of the cutting unit tabs
when reinstalling the rod bracket
13).
Important:
front) and Cutting Unit 5 (right front),
use the rod-bracket mounting nuts to
install the hose guides to the front of
the cutting-unit tabs. The hose guides
should lean toward the center cutting
unit (Figure 12
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
14
Figure
Figure 11
2. Rod bracket
(Figure
On Cutting Unit 4 (left
through Figure 14).
Figure 12
5. Cutting unit 5
6. Reel motor
7. Weight
11.
g003967
(Figure
g031275