Toro Reelmaster 7000-D Operator's Manual page 67

Figure 113
1. Rear screen latch
3. Clean the screen thoroughly of all debris.
Note:
To remove the screen, lift off the hinge
pins.
4. Clean both sides of the oil cooler/radiator area
(Figure 114) thoroughly with compressed air.
Start from the front and blow the debris out
toward the back. Then clean from the back
side and blow toward the front. Repeat the
procedure several times until all chaff and debris
is removed.
Figure 114
1. Oil cooler/radiator
Important:
with water will promote premature corrosion
damage to components and compact debris.
5. Close the rear screen and secure it with the
latch.
g200377
g020509
67
Cleaning the oil cooler/radiator