Product Overview; Controls - Toro Reelmaster 7000-D Operator's Manual

Product Overview

Controls

Brake Pedals
The 2 foot pedals (Figure
brakes for turning assistance and to aid in obtaining
better side hill traction.
Pedal-Locking Latch
The pedal-locking latch
pedals together to engage the parking brake.
Parking-Brake Pedal
To engage the parking brake,
pedals together with the pedal-locking latch, push
down on the right brake pedal while engaging the toe
pedal. To release the parking brake, press 1 of the
brake pedals until the parking-brake latch retracts.
1. Brake pedal
2. Pedal-locking latch
3. Parking-brake pedal
Traction Pedal
The traction pedal (Figure
reverse operation. Press the top of the pedal to move
forward and the bottom to move backward. Ground
speed depends on how far the pedal is pressed. For
no load, maximum ground speed, fully press the pedal
while the throttle is in the fast position.
To stop, reduce your foot pressure on the traction
pedal and allow it to return to the center position.
Tilt Steering Pedal
To tilt the steering wheel towards you, press the foot
pedal (Figure 25) down, and pull the steering tower
25) operate individual wheel
(Figure 25) connects the
(Figure 25) connect the
Figure 25
4. Traction pedal
5. Tilt-steering pedal
25) controls forward and
toward you to the most comfortable position and then
release the pedal.
Mow-Speed Limiter
When the mow-speed limiter
it will control the mow speed and allow the cutting
units to be engaged. Each spacer adjusts the mowing
speed by 0.8 km/h (0.5 mph). The more spacers
that there are on the top of the bolt, the slower the
machine moves. To transport the machine, flip back
the mow-speed limiter for maximum transport speed.
Speed-Limiter Screws
Adjust the screw(s)
the traction pedal can be pressed in the forward or
reverse direction to limit speed.
Important:
The speed-limiter screw must stop
the traction pedal before the pump reaches full
stroke or damage to the pump may occur.
g015074
1. Reverse speed limiter
screw
2. Forward speed limiter
screw
Lower Mow/Raise Control Lever
This lever (Figure
units and also starts and stops the reels when the
reels are enabled in the mow mode. The cutting units
cannot be lowered when the mow/transport lever is
in the transport position.
Key Switch
The key switch
O /P , and S
N REHEAT
InfoCenter
The InfoCenter LCD display shows information about
your machine such as the operating status, various
20
(Figure 26) is flipped up
(Figure 26) to limit the amount
Figure 26
3. Spacers
4. Mow speed limiter
27) raises and lowers the cutting
(Figure 27) has 3 positions: O
.
TART
g015075
,
FF