Figure 85
1. Service indicator
2. Latch
3.
Remove the cover from the air-cleaner body.
4.
Before removing the filter, use low-pressure
air—275 kPa (40 psi), clean and dry—to
help remove large accumulations of debris
packed between outside of primary filter and
the canister. Avoid using high-pressure air,
which could force dirt through the filter into
the intake tract.
This cleaning process prevents debris from
migrating into the intake when the primary filter
is removed.
5.
Remove and replace the primary filter
86).
Cleaning of the used element is not
recommended due to the possibility of damage
to the filter media. Inspect the new filter for
shipping damage, checking the sealing end of
the filter and the body. Do not use a damaged
element.
Insert the new filter by applying pressure to the
outer rim of the element to seat it in the canister.
Do not apply pressure to the flexible center
of the filter.
Figure 86
1. Primary filter
g011503
3. Cover
(Figure
g011504
Important:
Never attempt to clean the safety
filter
(Figure
with a new one after every 3 primary filter
services.
1. Safety filter
6.
Clean the dirt-ejection port located in the
removable cover.
7.
Remove the rubber outlet valve from the cover,
clean the cavity, and install the outlet valve.
8.
Install the cover, orienting the rubber outlet valve
in a downward position—between approximately
5 o'clock to 7 o'clock when viewed from the end.
9.
Reset the indicator
Servicing the Engine Oil
Oil Specification
Use high-quality, low-ash engine oil that meets or
exceeds the following specifications:
•
API service category CJ-4 or higher
•
ACEA service category E6
•
JASO service category DH-2
Important:
Using engine oil other than API CJ-4
or higher, ACEA E6, or JASO DH-2 may cause the
diesel particulate filter to plug or cause engine
damage.
Use the following engine oil viscosity grade:
•
Preferred oil: SAE 15W-40: above -18°C (0°F)
•
Alternate oil: SAE 10W-30 or 5W-30 (all
temperatures)
Toro Premium Engine Oil is available from your
authorized Toro distributor in either 15W-40 or 10W-30
viscosity grades.
55
87). Replace the safety filter
Figure 87
(Figure
84) if it shows red.
g011505