Table of Contents
Advertisement
Operation
This section describes the operation of the DTP2 T 212 transmitting switcher.
Topics include:
•
•
•
•
Front Panel Features
A
A
B
B
AUTO
SWITCH
R
A
B
C
Figure 7.
A
B
C
D
Front Panel Features
Operations
Connecting to the USB Port
Configuration
C
C
INPUTS
1
CONFIG
MODE
Auto Switch LED
Reset Button
USB Config port
DTP2 T 212 Front Panel
Auto Switch LED — Lights when Auto Switch is enabled.
Reset Button — With a tweeker or other pointed tool, press and hold the recessed
reset button for 3 seconds while operating the unit to reset back to factory default.
USB Configuration port — Connect a USB cable (USB A to mini-B) between your
computer and this female USB mini-B port to configure and control the switcher via SIS
commands or Product Configuration Software (PCS) and to update the firmware (see
Connecting to the USB Port
Input selection buttons and LEDs — Press one of these buttons to select an input to
switch to the output. The LED at the right of each button lights when the corresponding
input is selected.
If auto-input switching is in effect, these buttons are disabled, but the LEDs continue to
light to indicate the selected input (see
for the procedure to set up automatic input selection or the SIS command
Mode (unsolicited)
on page 42.
D
D
INPUTS
1
2
SIGNAL
HDCP
NORM/AUTO
Input selection buttons and LEDs
D
Signal Status LEDs
E
HDCP Status LEDs
F
on page 17).
Enabling Auto‑Input Switching
E
E
OUTPUTS
A
B
2
DTP2 T 212
F
F
on page 19
Auto Switch
DTP2 T 212 • Operation
14
Advertisement
Table of Contents
