Through-Desk Mounting; Rear Panel Features And Connections; Power Connection; Signal Input And Output Connections - Extron electronics SW2 VGAcc User Manual

im Vertrieb von
Installation

Through-desk mounting

Both SW2 models can be mounted through a table or podium,
using optional through-desk mounting brackets (Extron part
#70-077-02).
1. Attach the mounting brackets to the switcher with the
screws provided (figure 2-3).
2. Cut the proper sized hole in the mounting surface.
3. Hold the switcher with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm) deep
in the mounting surface at the marked screw locations.
5. Insert four #8 wood screws through the bracket and into the
four pilot holes. Tighten all four screws to secure the
switcher in place.
Figure 2-3 — Through-desk mounting

Rear Panel Features and Connections

All connectors are on the rear panel. Figure 2-4 shows the rear
panel of the SW2 VGAcc switcher, and figure 2-5 shows the rear
panel of the SW2 RGBHVcc.
www.camboard.de
2-4
SW2 VGAcc and SW2 RGBHVcc • Installation
CAMBOARD Electronics

Power connection

Signal input and output connections

Tel. 07131 911201
Fax 07131 911203
AC power connector — Plug a standard IEC power cord
1
into this connector to connect the switcher to a 100 to 240
VAC, 50/60 Hz power source.
2
100-240V 0.2A
INPUTS
1 2
50/60 Hz
1
Figure 2-4 — Rear panel – SW2 VGAcc switcher
2
INPUTS
100-240V 0.2A
R G B H V
1
R G B H V
2
50/60 Hz
1
Figure 2-5 — Rear panel – SW2 RGBHVcc switcher
Computer input connectors:
2
SW2 VGAcc — Connect your computer input (VGA,
SVGA, XGA, SXGA, UXGA, RGBHV, RGBS, RGsB or
RsGsBs computer video) to the 15-pin HD female
connectors.
SW2 RGBHVcc — Connect your computer input (RGBHV,
RGBS, RGsB, RsGsBs, component video, S-video (Y/C),
and composite video) to the BNC female connectors.
ce-info@camboard.de
SW2 VGAcc and SW2 RGBHVcc • Installation
3
OUTPUT
TALLY
CONTACT OUT
SW2 VGAcc 1 2 1 2
4
3
OUTPUT
R G B
H V TALLY
CONTACT OUT
SW2 RGBHVcc 1 2 1 2
4
2-5