Replacing The Dc Motor At The Tape Unwinder; Disassembling The Old Motor - DURKOPP ADLER 610-10 Additional Instructions

2

2.1 Disassembling the old motor

Fig. 1: Disassembling the old motor (1)
(1) - Cover
To disassemble the old motor:
1. Loosen the screws (2) on the cover (1).
2. Remove cover (1).
Fig. 2: Disassembling the old motor (2)
(3) - Circuit board
(4) - Screws
4

Replacing the DC motor at the tape unwinder

①
③
Replacing the DC motor at the tape unwinder
②
(2) - Screws
④
(5) - Motor cable
(6) - Cable of the proximity switch
Additional Instructions 610-10 - 00.0 - 04/2019
①
②
⑥
③
⑤