Hme4-5B Set Screw (M4X5) - THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual

18 Servo Installation-Part1
Assembly Tip: Remove all the servo wheels prior to attaching the steel linkage balls.
Make sure all linkages are the correct length.
(1)HSE2612N Self Tapping Screw(M2.6x12)......4
(2)HSE2620N Self Tapping Screw(M2.6x20)......4
(3)BK0075 Linkage Ball.......................................5
(4)BK0086 Ball Link.............................................9
(5)BK0104 Servo Mounting Plate........................ 6
(6)BK0105 Tail Control Rod Joint........................1
(7)BK0474 Rubber CAP...................................... 2
(8)BK0832 Body Support.....................................1
(9)HNLR6 R Pin...................................................2
Mount the Steel
Linkage Balls at 10.
5mm(approx 7/16")
from the center of the
servo horn.
(14)
Rudder Servo
(5)
(4)
(13)
Futaba
(18)
(13)
(2)
If you choose the rear servo plate to assembly, don't need to use #6, #12, #15.
(10)BK0833 Servo Block..................................... 2
(11)BK0840 SUS Linkage Rod (M2.3x46).......... 2
(12)BK0843 SUS Push Rod A.............................1
(13)BK0845 SUS Linkage Rod (M2.3x64)...........2
(14)HMC2516B Socket Screw (M2.5x16)........... 4

(15)HME4-5B Set Screw (M4x5)......................... 2

(16)HMF2-8N Screw (M2x8)................................5
(17)HML2 Nut (M2) ............................................ 5
(18)HMM25 Lock Nut (M2.5)............................... 4
Before installing Aileron
Servo, tape the wire as
shown.
(11)
18
(11)
70~73mm
Loctite
(4)
(1)
(5)
Aileron Servo
(10)
Elevator Servo
(5)
(4)
(16)
(3)
(17)
(9)
(8)
(7)