THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 11

7 Main Frame Assembly-Part3
Insert main shaft through the shaft bearings making sure that the end with the holes closest to the end is
pointed down. Next, slide main gear assembly into position on the shaft and line up the holes in the main
shaft with the holes in one way clutch shaft of the main gear assembly. Insert the socket head screw and
secure with the lock nut. Secure the main gear assembly just tight, do not overtorque the socket screw
as it might hurt the plastic autorotation gear. Next, slide on the mainshaft lock ring on top of the main shaft
bearing and secure with the two set screws. Then slide on the swashplate assembly and attach the elevator
and aileron control linkages to the outside swashplate linkage balls. Next, slide on washout assembly
and attach washout linkage to the inner linkage balls of the swashplate.
(1) BK0616 Socket Screw(M3x20)..............1
(2) HMM3Z Lock Nut (M3)..........................1
(3) HME4-5B Set Screw (M4x5).................2
(4) BK0086 Ball Link ..................................4
(5) BK0839 SUS Linkage Rod ...................2
(6) BK0030 Main Shaft Lock Ring...............1
(7) BK0702 Harden Main Shaft...................1
(8) Wash Out Assembly
(9) BV0092 Metal Swash Plate Assembly...1
(10) Main Gear Assembly
(4)
(5)
55mm
8 Engine Assembly
Note: A piston lock (TTR 1166P) purchased from your dealer will
make this a much easier task. You must replace the standard
throttle arm with the extended throttle arm and attach the linkage
ball.
(1) HMC3-10B Socket Screw(M3x10)..... 2
(2) BV0589 Clutch Shoe..........................1
(3) BV0143 Cooling Fan.......................... 1
(4) No.9605 TT PRO-50H(R) Engine.......1
(5) BK0170 Shim.....................................1
(6) BK0075 Link Ball................................1
(7) HMF2-8N Screw(M2x8)..................... 1
(8) HML2 Hex Nut (M2)........................... 1
(3)
(10)
(2)
(1)
Add Blue Loctite
(4)
10
(7)
(8)
(9)
(6)
(4)
(5)
(1)
(2)
(5)
Tighten the engine
nut securely by
grabbing the plastic
fan with a towel.
(3)
Linkage Ball to
throttle Arm
(7)
(6)
(8)