THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 8

4 Main Drive Gear Assembly
It is necessary to add grease inside the one way clutch before your
first flight. The clutch might lock up once grease is gone. The one
way grease( PV0517) or Ball differential grease is recommended for
this lubrication.
(1) HMC3-8B Socket Screw (M3x8).................4
(2) HMQ14 Snap Ring..................................... 2
(3) BV0033 One Way Clutch Housing............. 1
(4) BK0148 Main Spur Gear 85T......................1
(5) BK0610 Autorotation Tail Drive Pulley........1
(6) BK0034 One Way Clutch Shaft.................. 1
Add a drop of Blue Locktite on the
thread of each of these four screws.
5 Washout Assembly
Make sure linkage balls are attached to the
inside hole of each flybar control lever.
(1) HMJ2-10N Self Tapping Screw(M2x10).. 2
(2) HMC3-10B Socket Screw (M3x10)......... 2
(3) HMV740ZZY Bearing (d4xD7xW2.5).......4
(4) BK0077 Collar ........................................ 2
(5) BK0171 Pin............................................. 2
(6) BK0075 Linkage Ball.............................. 2
(7) BK0015 Flybar Control Lever.................. 2
(8) BK0016 Washout Linkage ..................... 2
(9) BK0014 Washout Base............................1
(10) HMS15 E Ring ...................................... 2
(8)
(10)
(2)
(5)
(5)
(1)
(3)
(3)
(4)
7
(2)
Outer hole is recommended
for 3D flying.
(7)
(6)
(3)
(9)
(1)
(6)
(7)
(2)
(3)
(4)
(1)
(6)
(2)
(4)
(3)
(10)
(5)
(8)