THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 21

20 Receiver/Gyro Installation
Thunder Tiger recognizes that there are many brands of radios and gyros to choose from. You are encouraged to
seek the advice of experienced helicopter pilots when making this decision.
(1) BE1052 Antenna Tube................... 1
(2) BK0106 Double Side Tape............ 2
Thunder Tiger TG-8000
piezo gyro and TG-7000
lock gyro is commended
21 Body/Canopy Assembly
Cut off the bubble from the body leaving the lip all the way
around. Neatness counts, so take your time. Next trim the
flange from the canopy leaving a clean edge. You can lightly
sand the edges to get it smooth and even. On the lip of the
opening in the body, mark six points for drilling holes to secure
canopy: 1-in front, 1-in rear and 2 on each side.
Using double stick tape secure canopy to body. Take a very
sharp awl and make pilot holes through the canopy and body
lip. Make sure all holes line up. Remove double stick tape
and put in the self tapping screws. Install the body clip, decals,
and rubber grommets.
(4)
(3)
(6)
(5)
If the Body will fall out during
backward 3D flying, we suggest
to install the self tapping scew (#1)
on Body Clip-A (#5).
(2)
(1)
(1)
(7)
(2)
20
On/Off Switch Face Plate
(1) HMJ2-6B Self Tapping Screw(M2x6)......7
(2) HSE3-12B Self Tapping Screw(M3x12)........ 2
(3) BK0611 Body.......................................... 1
(4) BK0102 Rubber Grommet ..................... 2
(5) BK0098 Body Clip-A............................... 1
(6) BK0099 Body Clip-B............................... 1
(7) BK0612 Canopy......................................1
Trim the hole and install the
rubber grommets as shown.
On/Off Switch
Gyro Amplifier
(2)
Receiver
(2)
Battery Pack
(2)
Body
Grommet