THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 12

9 Main Frame Assembly-Part4
Add blue Loctite to all metal to metal screw surfaces.
After installing the engine, connect the silicone fuel tube
to the carburator and muffler.
(1) HMC3-14B Socket Screw(M3x14).....10
(2) HMC3-35B Socket Screw(M3x35)...... 2
(3) BK0087 Flat Washer............................6
(4) BK0144 Engine Mount.........................1
(5) BV0172 Muffler....................................1
(6) Engine Assembly
(7) BA1579 Muffler Gasket........................1
(8) BK0179 Spacer....................................2
(9) HMT3B Spring Washer........................2
Engine Mount Notes:
The engine mount furnished will accommodate the Thunder Tiger 50H,
and the other heli engines. If you are installing a Thunder Tiger engine,
you will find the mount is wider than the engine crankcase. Two spacers
are furnished to accurately locate the engine while bolting it in place.
Remove these spacers after installation.
Spacer
Step1 Step2
Install the engine and Install the 4 mount screws
spacers into the engine and make sure the screws
mount. are tighten firmly.
10 Landing Skid Assembly
(1) HSE3-18B Self Tapping Screw(M3x18).4
(2) HME4-5B Set Screw(M4x5)..................4
(3) BK0066 Skid Brace...............................2
(4) BK0064T Skid Pipe...............................2
(5) BK0065 Skid Pipe End Cap..................4
The optional Thunder Tiger Remote Glow Plug
Adaptor(#3803) is recommended as shown, making
starting easier without the removal of your canopy.
(1)
(6)
(9)
(2)
Add Blue Locktite
(8)
(1)
Step3
Remove the spacers.
(3)
(1)
(2)
11
(7)
(3)
(1)
Add Blue
Loctite
(4)
(5)
(2)
(4)
(5)