THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 29

100mm
lengths
measured from
ball link center
to
ball link center
55mm
The above pushrod lengths will permit 3D with the Raptor.
Use these lengths as a starting point. Beginners can also use those pushrod lengths, but just connect the
collective control to the outside point on the pitch control arm. Pushrod lengths are measured from ball link
center to ball link center.
Suggested throttle and collective pitch set up: Idle-up1 is used for continuous 3-D flips and aerobatics.
Idle-up2 is used for switchless inverted hover. Use a pitch gauge to check blade angles. It is easier to start
setting up idle-up2 blade pitch angles first. Beginners should inhibit idle-up1, idle-up2. Beginners should
only use the Normal mode values. The model should hover at around 1550 rpm in Normal mode, and flies
at 1800 in idle-up1. Rotorspeed can be checked using TTR2000 MTF-301 helicopter tachometer.With 1700
or higher headspeed, the use of carbon blades is recommended.
CONFIGURING THE RAPTOR FOR 3D
Normal
Idle-up1 100 85 60 85 100
Idle-up2 100 60 55 80 100
Normal
Idle-up1
Idle-up2
Hold
Normal
Idle-up1
Idle-up2
Hold
10-12mm
28
5-Point Throttle Curves
0 30 50 75 100
5-Point Pitch Curves
18 38 55 75 94
0 22 46 70 90
0 22 46 70 90
15 38 55 75 100
Blade Pitch Angles (degrees)
-4 5.5 9.5
-9 0 9
-9 0 9
-6 5.5 10.5