THUNDER TIGER Titan Raptor 50 Size 3D Heli Assembly & Maintenance Manual page 26

(Hint for beginners)
Pitch Push Pull Lever Adjustment
Mount the Steel
Linkage Ball at
20mm from the
FUTABA
center of the Pitch
Push Pull Lever.
(Hint for beginners)
Mount the Steel
Linkage Ball at
13~15mm from the
FUTABA
center of the servo
horn.
5.5˚ hovering pitch angle is used for beginners, intermediates and experts. The throttle/collective must
be in the center position when adjusting the collective pushrod length to make the "point" line up with the
5.5˚ hover point on the molded scale(see above diagrams).
Setting up Main Rotor Blades Pitch Angle
The hoveing pitch angle should be at 5.5˚. To get the -2˚ to
11˚ collective range, mount the steel linkage ball at 13~15mm
away from the center of the collective servo horn.
25
5.5˚
Throttle Stick in the center
position
5.5˚
Throttle Stick in the center
position