Usb Connection For Field Programming - Pentair FOLEO 5800 XTR Installer Manual

NOTE

Degree hardness units are converted to ppm upon input. Degree inputs may be rounded up
or down to the nearest ppm equivalent.
Press the screen navigation arrows at the upper-right and left of the screen to navigate to the
assistance name, assistance phone, and assistance interval screens. See 5.2. Quick program guide,
page 42 for more information about these settings.
Press to save changes or press

5.4.2. USB connection for field programming

The XTR features a USB port that allows you to connect a PC to the controller for field programming
and diagnostic parameter download.
NOTE

Field programmer software is required for field programming features. See XTR field
programmer manual for more information on using the field programmer software.
NOTE

Do not remove USB cable from computer or controller while connected and transferring.
From the format screen, press
When the USB screen appears, connect a USB cable to the USB port on the controller circuit board
(see 4.5.10. Electrical connection, page 38 for location of USB port). Connect the other end of the USB
cable to a PC with the field programmer software installed and follow the directions in the XTR field
programmer manual to complete the connection.
Press to return to master settings.
Ref. MKT-IM-038 / C - 15.11.2019
to return to the master setting screen without saving.
to access the USB screen.
USB
Connect the usb cable to the
control and PC and start
the field programming
application
Installer Manual Foleo - Programming
53 / 112