User Programming Mode - Pentair 5600SXT Series Operator's Manual

USER PROGRAMMING MODE

User Programming Mode Options
Abbreviation Parameter
DO Day.Override
RT Regeneration.
Time
H Feed Water
Hardness
RC or SF Reserve.Capacity
CD Current.Day
NOTE:.. Some.items.may.not.be.shown.depending.on.timer.
configuration..The.timer.will.discard.any.changes.and.
exit.User.Mode.if.any.button.is.not.pressed.for.sixty.
seconds.
User Programming Mode Steps
1.. Press.the.Up.and.Down.buttons.for.five.seconds.while.in.
service,.and.the.time.of.day.is.NOT.set.to.12:01.PM.
2.. Use.this.display.to.adjust.the.Day.Override..This.option.
setting.is.identified.by."DO".in.the.upper.left.hand.corner.of.
the.screen.
3.. Press.the.Extra.Cycle.button..Use.this.display.to.adjust.the.
Regeneration.Time..This.option.setting.is.identified.by."RT".in.
the.upper.left.hand.corner.of.the.screen.
4.. Press.the.Extra.Cycle.button..Use.this.display.to.adjust.the.
Feed.Water.Hardness..This.option.setting.is.identified.by."H".
in.the.upper.left.hand.corner.of.the.screen.
Range:.1-199.hardness
5.. Press.the.Extra.Cycle.button..Use.this.display.to.adjust.the.
Fixed.Reserve.Capacity..This.option.setting.is.identified.by.
"RC".or."SF".in.the.upper.left-hand.Corner.of.the.screen..
10 • Pentair.5600SXT.Softener.System
Description
The.timer' s .day.override.setting
The.time.of.day.that.the.system.
will.regenerate.(meter.delayed,.
time.clock,.and.day-of-week.
systems)
The.hardness.of.the.inlet.water.
-.used.to.calculate.system.
capacity.for.metered.systems
The.fixed.reserve.capacity
The.current.day.of.week
6.. Press.the.Extra.Cycle.button..Use.this.display.to.set.the.
Current.Day.of.the.Week..This.option.setting.is.identified.by.
"CD".in.the.upper.left.hand.corner.of.the.screen.
7.. Press.the.Extra.Cycle.button.to.end.User.Programming.Mode.