Table of Contents
Advertisement
TANDBERG 8000 MXP
2.2
Connecting Cables
All cables needed in standard configuration are connected to the system. Connect these
cables to the other parts of the system:
1. Power cable
Connect the system power cable to an electrical distribution socket.
2. Monitor cables
Connect to the VGA input of each monitor the 1,5m VGA-DVI cable and the power cable.
You will find the cables coiled up in the base. There will be a coil for each monitor. Switch
on the monitors. Make sure that the cable marked "Main Monitor" is connected to the main
monitor and that the cable marked "Dual Monitor" is connected to the dual monitor.
3. Microphone cable
Connect the microphone cables to the microphones.
4. Camera cable
Connect the camera and the camera cable.
5a. ISDN cables - using BRI interface
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service
provider. Your main number will be the number associated with the socket to which ISDN
cable number 1 is connected. The system does not have a built-in network terminator. If
your sockets provides you with an ISDN U-interface, you will need an NT! between your
system and your ISDN line, see
5b. ISDN cable - using the PRI interface
If you are using the PRI interface, the E1/T1 cable should be connected to a CSU (Channel
Service Unit). You will
need a CSU between your system and the PRI line from your network provider, see
Appendix
6.
5c. Other networks - using the External Network interface
If you are using other networks, please refer to chapter
and
Appendix
8.
6. LAN cable
To use the system on LAN, connect a LAN cable from the 'Ethernet' connector on the
system to your LAN.
16
Appendix
9.
4.8.1 ISDN/External/Leased E1/T1
Advertisement
Table of Contents
