Unpacking And Installation; Assembling The Unit; Mounting The (Optional) Handset; Connecting Cables - TANDBERG 150 MXP Administrator's Manual

Unpacking and Installation

Assembling the Unit

Assembling the unit is really easy. The system lies fully as-
sembled in the box. Remove the accessories box and carefully
lift the system out of the box. To protect the camera lens while
installing, we recommend that you let the camera lens cap
remain on. In the accessories box you should find:
•
LAN cable
•
Power adapter and power cable
Please report any discrepancies to your TANDBERG Representa-
tive immediately.

Mounting the (optional) Handset

Handset is an optional device that must be ordered separately.
Contact your TANDBERG representative for more information.
Slide the handset brack-
et into the system's
bottom plate tracks.
Place the system in an
upright position and lay
the handset in its place.
The handset is held in
place by magnets.
Table of Trademarks & Patents &
Contents Copyright Disclaimers

D 14127.01

01.2008
Power
Connect Connect your
here. (Local Area Network)
here.
About
Safety/ To Get You To Get You
Administrator
Environmental Up and Going Up and Going
Settings

Connecting Cables

LAN If you have a single LAN connec-
tion only and this is in use by your
PC already, connect your PC to the
150MXP and the 150MXP
LAN to let both units have internet
access.
General Audio
Settings Settings
12
ADMINISTRATOR'S GUIDE
Socket for optional handset's cable.
See lower left corner of this page for
details.
Socket for optional headset.
BERG 150MXP has a 2.5mm 3-pole mini-
jack connector at its right side marked
with a headset symbol. This allows the
user to connect a standard telecommuni-
cations headset to the system.
Headsets with the microphone positioned
in front of the user's mouth, connected to
the earphone through a rod, tend to give
more echo than earbud headsets with
the microphone attached to the cord.
TANDBERG recommends the Plantronics
MX100 headset (http://www.plantronics.
com, products > mobile).
Note that the maximum outer diameter
of the plug must be 7.0 mm or smaller.
A plug with a bigger outer diameter will
not fit the unit. Alternatively an extension
cord may be used.
How to configure the unit is
described in Administrator
Settings.
to the
Security Network
Profiles &
Settings Settings
Wizard
TANDBERG 150MXP
The TAND-
Diagnostics
Reset &
Upgrade