Table of Contents
Advertisement
1 Introduction
Monitors
The main monitor displays the far-end and near-end videoconferencing sites in addition to the
menus and video from connected video sources. The second monitor displays selfview,
Snapshots and Duo Video.
Codec
The Codec is the heart of the system. The main task for the Codec is the compression of
outgoing video, audio and data, the transmission of this information to the far end and the
decompression of the incoming information. -Hence the name Codec; compression and
decompression.
Remote Control
The remote control is used to control all functions of the system. If the screen saver is
activated (black monitor), touching the remote control will automatically wake up the system.
The remote control uses 4 AAA batteries. The system will tell you when batteries are running
low. Change batteries from the backside of the remote control.
The reach of the remote control signal is 20 meters. For users sitting in an open plan office,
this can cause problems. Use the little, white switch placed under the batteries to change the
reach of the signal from 20 meters to 2 meters. This will prevent you from unintentionally
controlling your neighbor's video system, when you control your own system.
Table microphone
The high quality table microphone is designed to use on a table during a videoconference.
You can connect up to three microphones. The ideal location for the microphone is on a flat
surface at least 2m (6.5 ft) from the front of the system. The microphone cable should always
9
Advertisement
Table of Contents
