Table of Contents
Advertisement
CAUTION!
Avoid displaying the same images continuously over a long
period of time on the monitors.
Displaying the same images such as still images for a long time may cause after-image
lagging. This may occur in the following two cases:
1. After image lagging due to remaining electrical load
When image patterns with very high peak luminance are displayed for more than 1 minute,
after-image lagging
may occur due to the remaining electric load. The after-images remaining on the screen
will disappear when
moving images are displayed. The time for the after-images to disappear depends on the
luminance of the still
images and the time they had been displayed.
2. After-image lagging due to sticking
When images of the same pattern are displayed continuously for several hours or
displayed for a short period of
time every day, after-images may remain on the screen due to the sticking of the
fluorescent materials. In this
case, these images may decrease if moving images are displayed after them, but basically
they will not
disappear.
Solving after-image lagging problems
If you have got after-image lagging on your monitors, you can reduce the problem to an
acceptable level by
displaying a white image on the monitors for a few hours. This can be accomplished by
focusing the camera
towards a white paper and setting maximum brightness. See the 'User Manual' for details.
NOTE: Warranty may be invalidated if the precautions listed above are not followed.
1
Advertisement
Table of Contents
