General Use - TANDBERG F1 D13353.02 User Manual

3 General Use

Wake up the system
When the system is not in use, it is in standby mode and the screens are black. Wake up the
system by picking up the remote control. An incoming call or pressing any key on the remote
will also wake up the system.
If the system does not respond:
 Make sure that the system is switched on by using the On/Off switch located at the
rear of the Codec.
 Verify that your monitor is switched on. To switch the monitor on you normally push
the power button on the front of the monitor (depending on monitor type)
20