Isdn-Bri Settings - TANDBERG F1 D13353.02 User Manual

4.8.1.1 ISDN-BRI Settings

To make sure your system will work properly using ISDN-BRI, make the following
settings:
1. Set ISDN switch type
2. Enter ISDN line numbers (+ SPIDs if required)
3. Disable unused lines
Some software versions do not support 6 ISDN lines, therefore some of the Line Setup
entries may be grayed out.
4.8.1.1.1 ISDN BRI switch type
Select the type of ISDN network connected to your unit. Note that 1TR6 should only be used
if you are operating the system behind a PABX.
4.8.1.1.2 Line setup
This menu allows you to program the numbers associated with your ISDN line. If you want to
use this ISDN line, you need to set Enabled On and enter the numbers of your ISDN line. If
some of the ISDN lines are not to be used, set Enabled Off. Line 1 should always be enabled.
National ISDN and AT&T Custom ISDN might require SPID numbers associated with your
ISDN numbers. If you have received two different SPID (Service Profile IDentifier) numbers
for each ISDN line from your network provider, you must program both.
Example:
ISDN BRI 1:
ISDN BRI 2:
ISDN BRI 3:
ISDN BRI 4:
ISDN BRI 5:
ISDN BRI 6:
4.8.1.1.3 Advanced ISDN Settings
Sub address
Using a sub address enables you to connect up to eight ISDN terminals to the same ISDN
telephone number and line. The terminals are addressed by using different sub addresses. To
Numbers
67838498
67838498
23478060
23478070
23478420
23478430
23478520
23478530
23478540
23478550
23478560
23478570
4 Administrator Settings
SPIDS
016783849800
016783849810
012347806000
012347807000
012347842000
012347843000
012347852000
012347853000
012347854000
012347855000
012347856000
012347857000
101