Unpacking And Mounting - TANDBERG F1 D13353.02 User Manual

TANDBERG 8000 MXP

2.1 Unpacking and Mounting

Unpacking the System
To avoid damage to the unit during transportation the system is delivered as separate
components:
 Base
 Monitor Frame
 Two Plasma Monitors
Together with the Base you will find the monitor connector units, the monitor rear covers and
the accessories box which will contain the following:
 W.A.V.E. II Camera
 Three Table Microphones
 Remote Control and Tracker with batteries
 Cables
 Documentation
Unpacking the Base
Due to the weight of the system, the base should be placed in its permanent location as soon
as it is unpacked.
Unpacking and Installing the Monitor Frame
Lift the monitor frame out of the box. Do not remove the straps or packaging that are around
the rack. Place the rack on top of the base. Make sure that the cables from the base do not
get stuck in between. You will find 4 bolts sticking out at the rear end of the base. Use the 4
nuts to fasten the monitor frame in place. You can now remove the straps and packaging from
the monitor frame.
IMPORTANT: Put your fingers in the holes on the side of the plastic cover and carefully flip
down the plastic cover. Two persons should carry out this operation to avoid too much stress
on the plastic cover. 4 hexagonal-shaped screws should be used to secure the monitor frame
to the top of the Base. There are 2 holes
located on each side. The front cover is made of plastic and should be treated with care.
Installing the monitor(s)
We recommend that there are 3 people present when installing the monitor(s):
 Remove the plastic plugs located on the back of the monitor(s). Check to see where
the holes in the monitor frame are located.
 Take the monitor(s) and place it (them) inside the monitor frame.
 Secure each monitor with the 8mm hexagonal-shaped screws.
 Remove the protective plastic film from the monitor front.
 The monitor connector units should be mounted at the rear of each monitor. Please
see the instructions that comes with the connector (video) unit for correct installation.
Remember that there should be a gap on each side of the monitor.
Be careful when removing the plastic film. Do not pull the plastic off the monitor at a 90º
angle as this may damage the screen. Instead you should remove the plastic film by
pulling it parallel with the screen at a 180º angle.
14