Table of Contents
Advertisement
Refer to Glass Frame Assembly Identification Figures 6A & 6B.1 when installing and removing the glass frame assembly.
B. INSTALL GLASS FRAME ASSEMBLY
U-Shaped
Edge
Protector
Figure 6B.2 - Outer Edge Protector
Figure 6B.3 - Vertical Trim Piece
Figure 6B.4 - Horizontal Trim Piece
C. REMOVE GLASS FRAME ASSEMBLY
1.
Apply the suction cups to the outer glass panel following the instructions included with the suction cups.
2.
Gently lift the glass until the bottom edge is clear of the groove it sits in.
3.
Bring the bottom edge of the glass towards you while lowering it to disengage it from the top groove.
4.
Set the glass on a padded surface to protect it. IMPORTANT: Protect the glass's edges.
5.
Remove the lower trim panel that sits between the layer of glass.
6.
Remove the inner trim vertical panels.
7.
Using the suction cups, remove the inner panel in the same manner.
Heat & Glo • FDN-4-PIER, FDN-5-PIER, FDN-6-PIER, FDN-7-PIER Installation Manual • 16400-9803 • 2/19
6 - GLASS FRAME ASSEMBLY
Top/Bottom Glass Pane
IMPORTANT: PLASTIC EDGE PROTECTORS
The fireplace is shipped with plastic edge protectors that
are u-shaped channel pieces wrapped separately and
shipped on top of the glass packaging.
These will be placed on the outer panes of glass only prior
to installing onto the fireplace. If the edge protectors are
not installed, the glass may rattle during operation. See
Figure 6B.2.
Inner Glass
1. Unwrap the panes of glass carefully making sure to protect the
edges.
2. Apply the suction cups to the inner glass assembly, following in-
structions included with the suction cups.
3. Lift the glass into place. The top edge slips into the top groove, lift
into the groove until the bottom is clear of the bottom trim. Slide
the glass down into the inner bottom groove. See Figure 6A.
4. Push inner trim vertical panels into place on each side. See Fig-
ure 6B.3.
5. Place the lower trim panel between the lower glass clips. Slide
back against the vertical trim piece. See Figure 6B.4.
Outer Glass Edge Protectors
6. For the panes of glass that make up the outer set of glass, the top
and bottom edges must be first clad in the provided plastic edge
protectors.
7. Line the top and bottom edges of the outer glass with the edge
protectors so that the glass edge slides completely into the chan-
nel of the edge protector from one end to the other. Press in
firmly. No adhesive required. See Figure 6B.2. Long pieces of
glass may need two or more protectors.
8. After the panes are clad in the edge protectors on the top and
bottom edges, install glass into outer channels.
Outer Glass
9. Apply the suction cups to the outer unframed glass and lift it into
place in the same manner as the inner glass.
15
Hide quick links:
Advertisement
Table of Contents
