Resetting The Eda; Performing A Warm Boot; Performing A Cold Boot - Symbol MC70 User Manual

2 - 24 MC70 User Guide
Pick List Mode with Multiple Bar Codes in Aiming Pattern
Figure 2-21
Release the scan button.
4.
Imager decoding usually occurs instantaneously. The EDA repeats the steps required to
NOTE
take a digital picture (image) of a poor or difficult bar code as long as the scan button remains
pressed.

Resetting the EDA

There are two reset functions, warm boot and cold boot. A warm boot restarts the EDA by closing all running
programs. A cold boot also restarts the EDA, and also resets the clock. Data saved in flash memory or a
memory card is not lost.
Perform a warm boot first. If the EDA still does not respond, perform a cold boot.

Performing a Warm Boot

Hold down the Power button for approximately five seconds. As soon as the EDA starts to boot release the
Power button.

Performing a Cold Boot

To perform a cold boot simultaneously press the Power button and the and keys.
1 9