Imager Scanning - Symbol MC70 User Manual

Imager Scanning

Ensure that a scan-enabled application is loaded on the EDA.
1.
Aim the scan window at the bar code.
2.
Imager Scanning
Figure 2-18
Press the scan button. The red laser aiming pattern turns on to assist in aiming. Ensure the bar code is
3.
within the area formed by the brackets in the aiming pattern. The Scan/Decode LED lights red to indicate
that scanning is in process, then lights green and a beep sounds, by default, to indicate the bar code was
decoded successfully. Note that when the EDA is in Pick List Mode, the imager does not decode the bar
code until the crosshair touches the bar code.
Linear bar code
Imager Aiming Pattern: Bar Code Centered
Figure 2-19
Correct
Imager Aiming Pattern: Bar Code Not Centered
Figure 2-20
PDF417 symbol
Symbol
View Finder
(Aiming Pattern)
Correct
Incorrect
Using the MC70 2 - 23