Table of Contents
Advertisement
8-Port Gigabit (PoE+) Ethernet Smart Managed Pro Switch with (2 SFP or 2 Copper Ports and)
-
Deny. Drop packets that meet the ACL criteria.
Logging. If the selection form the Action menu is Deny, you can enable logging
for the ACL by selecting the Enable radio button. (Logging is subject to resource
availability in the device.)
•
Interface. For a Permit action, use either a mirror interface or a redirect interface:
-
Select the Mirror radio button and use the menu to specify the egress interface to
which the matching traffic stream is copied, in addition to being forwarded
normally by the device.
-
Select the Redirect radio button and use the menu to specify the egress interface
to which the matching traffic stream is forced, bypassing any forwarding decision
normally performed by the device.
•
Match Every. Select one of the radio buttons to specify whether all packets must
match the selected IP ACL rule:
-
False. Not all packets need to match the selected IP ACL rule. You can configure
other match criteria on the page.
-
True. All packets must match the selected IP ACL rule and are either permitted or
denied. In this case, you cannot configure other match criteria on the page.
•
Protocol Type. From the menu, select a protocol that a packet's IP protocol must be
matched against: IP, ICMP, IGMP, TCP, UDP, EIGRP, GRE, IPINIP, OSPF, PIM, or
Other. If you select Other, enter a protocol number from 0 to 255.
•
Src. In the Src field, enter a source IP address, using dotted-decimal notation, to be
compared to a packet's source IP address as a match criterion for the selected IP
ACL rule:
-
If you select the IP Address radio button, enter an IP address or an IP address
range. You can enter a relevant wildcard mask to apply this criteria. If this field is
left empty, it means any.
-
If you select the Host radio button, the wildcard mask is configured as 0.0.0.0. If
this field is left empty, it means any.
The wildcard mask determines which bits are used and which bits are ignored. A
wildcard mask of 0.0.0.0 indicates that none of the bits are important. A wildcard of
255.255.255.255 indicates that all of the bits are important.
•
Src L4. The options are available only when the protocol is set to TCP or UDP. Use the
source L4 port option to specify relevant matching conditions for L4 port numbers in
the extended ACL rule.
You can select either the Port radio button or the Range radio button:
-
Port. If you select the Port radio button, you can either enter the port number
yourself or select one of the following protocols from the menu:
•
The source IP TCP port protocols are domain, echo, ftp, ftpdata, www-http,
smtp, telnet, pop2, pop3, and bgp.
•
The source IP UDP port protocols are domain, echo, snmp, ntp, rip, time,
who, and tftp.
Manage Device Security
Cloud Management
385
User Manual
Hide quick links:
Advertisement
Table of Contents
