If Condensation Is Found In Tubes During A Run; If The Sealed Microplate Loses Sample Volume; If Usb Devices Including Memory Stick And Keyboard Not Recognized; If Cycler Does Not Turn On - Agilent Technologies SureCycler 8800 Setup And User Manual

If condensation is found in tubes during a run

Condensation will appear naturally at the end of a run and has no
deleterious effects.
✔
The hot top is disabled.
✔

If the sealed microplate loses sample volume

✔
✔
If USB devices including memory stick and keyboard not
recognized
✔

If cycler does not turn on

✔
✔
Agilent SureCycler 8800 Setup and User's Guide
Spin the liquid back to the bottom of the tube and continue with the
post PCR steps.
Enable the hot top using the instructions in
page 32.
Check that the microplate/sealing system is of good quality.
Ensure a compression mat is used during the PCR run to keep the
sealing film adhered to the plate.
Reboot the cycler.
Check that the power is on at supply and the power cord is connected.
Check fuses at rear of instrument above power inlet.
If condensation is found in tubes during a run
"Hot Top Setting"
PCR Programs 4
on
59