Changing The Print Area - Roland LEF-300 Master Manual

4.
Press [ ] or [ ] to select a value .
SET AT SETUP
DISABLE
(Default setting)
ENABLE
5.
Press [ENTER] .
6.
Press [MENU], then [ ] to go back to the original screen .

Changing the Print Area

In the factory defaults, the base position (home position) of the print area is at the right front of the flat table
and the print area is the full area (770 × 330 mm
The base position of the print area should be changed according to the shape of the media .
You can reduce the print time if you narrow (limit) the print area .
Determining the Base Position of the Print Area (Home Position)
Determine the home position used as the base to set the print area .
1.
Press [MENU] .
2.
Press [ ] twice to display the screen shown below .
MENU
SUB MENU
3.
Press [ ] .
4.
Press [ ] to display the screen shown below .
SUB MENU
SET BASE POS.
5.
Press [ ] .
SET BASE POS.
LOWER R LOWER R
Explanation
Setup is performed using the print area of the previous setup .
The factory default print area is the full area (770 × 330 mm [30 .3 × 13 in .]) .
This setting is suitable when you always perform printing on media of a fixed size .
Set the print area (base position, width, and length of the print area) every time you set
up the media .
Select this value when the media shape changes for each printing operation .
[30 .3 × 13 in .]
Performing Advanced Setup of the Media
) .
Chapter 1 Fully Utilizing the Machine 13