Table of Contents
Advertisement
5.
Press [ ], [ ], [ ], or [ ] to move the laser pointer until it points to a position to the right foreground of
the print area .
6.
Press [ENTER] .
The print heads return to the home position .
WIDTH: 000.0mm
LENGTH:000.0mm
MEMO
When the media comes into contact with the head gap sensor, the screen shown below appears and the
setup is canceled . Perform operations again from "2 . Setting the Height of the Media Automatically" (First
Step Guide) or "Media Suction Function Setting" (p . 9) .
CHECK TABLE
HEIGHT
7.
Press [ ], [ ], [ ], or [ ] .
The flat table moves to the front and the print heads move to the left side of the flat table .
8.
Press [ ], [ ], [ ], or [ ] to move the laser pointer until it points to a position to the inner left of the print area .
Performing Advanced Setup of the Media
Right foreground of the print area
Inner left of the print area
Chapter 1 Fully Utilizing the Machine
15
Advertisement
Table of Contents
