Table of Contents
Advertisement
Handling Messages and Error Messages
Message
READJUST TABLE HEIGHT
INSTALL DRAIN BOTTLE
EMPTY DRAIN BOTTLE
SETUP MEDIA
TIME FOR FILTER REPLACE
TIME FOR MAINTENANCE
TIME FOR WIPER REPLACE
86
Chapter 3 Appendix
Explanation
During printing, the media
came into contact with the
gap sensor, but [CLEARANCE
MODE] is set to [RE-ADJ.], so
the media height was reset
automatically and printing
was performed to completion.
Check whether the drain
bottle is installed.
This appears when a certain
amount of discharged fluid
collects in the drain bottle.
This message appears when
an attempt to perform a
printing test was made while
no media was loaded.
It is time to replace the filter.
It is time to perform manual
cleaning.
It is time to replace the wipers.
Action
After verifying the message,
press [ENTER].
Install the drain bottle, and
then press [ENTER].
When this message is
displayed, discard the
discharged fluid.
Reload the media and press
[SETUP].
After verifying the message,
press [ENTER].
Page
• "Setting the Height of the
Media Manually" (p. 9)
• "Changing the Print Area"
(p. 13)
• "Continuing Printing
Even If Media Comes into
Contact with the Head
Gap Sensor" (p. 27)
—
• "Disposing of Discharged
Fluid" (p. 46)
—
• "Replacing the Filter" (p.
69)
• "Manual Cleaning" (p.
52)
• "Replacing the Wipers" (p.
66)
Advertisement
Table of Contents
