Table of Contents
Advertisement
5.
Pull on the signal tower wires to check that they have been securely connected to the machine .
6.
Turn on the machine's main power and sub power .
7.
Press [SETUP] and check that the signal tower turns on .
Removing the signal tower
1.
Turn off the machine's main power and sub power .
2.
Remove the signal tower wires .
Using Expansion Terminal B to Connect an External Device
In order to connect a device to expansion terminal B, you have to set the expansion terminal to "ENABLE . "
WARNING Perform this work with all power switches left switched off .
Failure to observe this instruction may cause the machine to move suddenly, resulting in injury .
Procedure
1.
Check that the machine's main power and sub power switches are off .
2.
Attach to expansion terminal B the terminal to which you want to connect an external device .
" "Specifications and Diagrams for the External Expansion Terminal" (p . 90)
3.
Turn on the machine's main power and sub power .
Expansion
terminal B
Connecting External Devices
Chapter 1 Fully Utilizing the Machine
39
Advertisement
Table of Contents
