Table of Contents
Advertisement
Replacing Consumable Parts
Replacing the Wipers
The wipers are components that are used when cleaning the print heads. When the screen displays a
message like the one shown below, it is time to replace the items. Replace them with new items.
For information about purchasing wipers, contact your authorized Roland DG Corp. dealer.
TIME FOR
WIPER REPLACE
When a warning beep sounds during wiper replacement
A warning beep sounds 10 minutes after operation begins. Stop work and close the front cover. Press [ENTER]
to exit the wiper replacement menu. After that, restart the procedure from the beginning.
CAUTION
Be sure to perform operations as specified by the instructions above, and never touch any area not
specified in the instructions�
Failure to observe this instruction may cause the machine to move suddenly, resulting in injury.
1� Enter the REPLACE WIPER Mode
NOTE
Be sure to hold the handle of the front cover and open and close it gently.
1.
When the message shown in the figure appears, press [ENTER]�
TIME FOR
WIPER REPLACE
2.
Remove any media�
3.
Press [MENU]�
4.
Press [ ] twice to display the screen shown below�
MENU
SUB MENU
5.
Press [ ], then [ ]�
SUB MENU
MAINTENANCE
66
Chapter 2 Maintenance
Advertisement
Table of Contents
