Table of Contents
Advertisement
Read This Section Whenever You Face a Problem (FAQ)
Printer Does Not Run
Problem
Items to check
Is the power switched on?
Is [SETUP] lit?
Are any covers open?
Is the top menu displayed?
The printer unit
does not run
Is [PAUSE ] lit?
Has ink run out?
Is a message displayed on
the screen?
Are the cables connected?
80
Chapter 3 Appendix
Action
Switch on the printer's main power, and then press
the sub power switch and make sure the sub power
switch lights.
If [SETUP] is not lit, the printer cannot print.
Configure the settings all the way to the setting of
the print area, close the front cover, and then press
[SETUP].
Close the front cover, panel cover, and maintenance
cover.
If the top menu is not displayed, printing will not
start even when data is sent from the computer. To
go to the top menu, press [MENU], and then press
[ ].
W:770mm L:330mm
H:100mm
When [PAUSE / VACUUM] is lit, operation is paused.
To resume, press [PAUSE / VACUUM]. [PAUSE/
VACUUM] turns off and printing resumes.
When data is sent while the screen shown in the
figure is displayed, a message appears and a warning
beep sounds. At the same time, operation pauses.
When the ink cartridge is replaced with a new one,
printing starts.
1
2,, 3,, 4,,
5,, 6,,
• "A Message Appears" (p. 85)
• "An Error Message Appears" (p. 87)
Connect the cables securely.
Page
• "STEP 1: Turning the
Power On" (First Step
Guide)
• "1. Loading Media
(Media Setup)" (First
Step Guide)
—
—
• "Pausing or Cancel-
ing Printing" (First
Step Guide)
• "How to Replace Ink
Cartridges" (p. 58)
• "STEP 5: Connecting
the Cables" (First
Step Guide)
Advertisement
Table of Contents
