Adjusting The Distance Between The Object To Be Printed On And The Print Heads - Roland VersaUV LEF2-200 User Manual

Adjusting the Distance between the Object to Be Printed On and the Print Heads

If the height (thickness) of the object to be printed on varies or if the object to be printed on is lifted or warped
during printing, the object to be printed on might come into contact with the print heads. You can expand the
distance between the object to be printed on and the print heads in advance to prevent issues like this from hap-
pening.
IMPORTANT
• If the distance is expanded too much, the print quality may be deteriorated and the nozzles of the print heads may be clogged.
Configure the settings so that the distance between the highest position of the object to be printed on and the lowest position of
the print surface is 2 mm (78.7 mil) or less.
• This setting is enabled when the height of the object to be printed on is set automatically.
P. 70「4.The height of the object to be printed on is detected automatically.」
Procedure
1.
Press [MENU].
2.
Press [▼] to display the screen shown below.
3.
Press [▶].
4.
Press [▼] several times to display the screen shown below.
SUB MENU
AUTO DOWN
5.
Press [▶].
AUTO DOWN
0.0mm 1.5mm
6.
Press [▲] or [▼] to set the distance between the object to be printed on and the print heads.
You can adjust the distance in increments of 0.1 mm (3.9 mil).
AUTO DOWN
0.0 mm (default setting)
:
2.0 mm (78.7 mil)
7.
Press [ENTER] to confirm your entry.
8.
Press [MENU], then [◀] to go back to the original screen.
Distance between the object to be printed on and the print heads
1.0 mm (39.4 mil)
:
3.0 mm (118.1 mil)
Adjusting the Height
1. Optimizing the Setup Method
61