Changing Just The Base (Home) Position - Roland VersaUV LEF2-200 User Manual

Changing Just the Base (Home) Position

You can change just the base (home) position for each printing operation. Even if you change the base position,
the diagonal position does not change, so the "WIDTH" and "LENGTH" values are changed according to the change
to the base position.
1.
Check that "SET BASE POS." is set to "LOWER R."
Procedure
1.
Press [MENU].
2.
Press [▼] to display the screen shown below.
MENU
SUB MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
SUB MENU
SET BASE POS.
4.
Press [▶] to display the screen shown below.
SET BASE POS.
CENTER LOWER R
5.
If "CENTER" is selected, press [▲] or [▼] to select "LOWER R".
If "LOWER R" is already selected, proceed to step 7.
SET BASE POS.
CENTER LOWER R
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU], then [◀] to go back to the original screen.
Print Area Settings
1. Optimizing the Setup Method
73