Head Refreshing Method - Roland VersaUV LEF2-200 User Manual

Head Refreshing Method

Head refreshing is an important operation that prevents clogging of the print heads.
Refresh the heads:
• After daily operations.
• When the message "DO HEAD REFRESH" appears.
• When dot drop-out or dot displacement occurs.
• When an emergency stop occurs.
• When switching on the main power and sub power after the main power was previously switched off.
Head refresher
IMPORTANT
Be sure to hold the handle of the front cover and open and close it gently.
Procedure
1.
If [SETUP] is lit, hold down [SETUP] for 1 second or more to cancel setup.
[SETUP] turns off, and the flat table comes forward.
2.
If the following message is displayed, press [ENTER].
If this message is not displayed, start from step 5.
DO HEAD REFRESH
3.
Press [◀] or [▶] to select "YES".
DO REFRESH?
[YES] NO
MEMO
Selecting "NO" returns the display to the top menu (or initiates automatic cleaning, depending on the printer status). However,
the same message will be displayed once a certain amount of time has passed and in specific situations (such as before the
start of manual cleaning and during wiper replacement). Head refreshing is an important operation that keeps the print heads
in good condition. Perform this operation with as close to the appropriate timing as possible.
4.
Press [ENTER].
Proceed to step 8.
5.
Press [FUNCTION].
6.
Press [▶] to display the screen shown below.
CLEANING
HEAD REFRESH
7.
Press [ENTER].
8.
When the following screen is displayed, open the front cover.
Required items
Head cleaning sheet Cleaning liquid for head refresh-
Maintenance That Must Be Performed Daily
ing
2. Regular Maintenance
133