Rep 8.25 Tray 5 Feed Sensor - Xerox WorkCentre 5790 Series Service Manual

REP 8.25 Tray 5 Feed Sensor

Parts List on PL 8.45
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the top cover, PL 7.60 Item
2. Prepare to remove the tray 5 feed sensor,
1 2
Disconnect the harness. Remove eight screws marked A.
Figure 1 Preparation
Repairs/Adjustments
REP 8.25
WARNING
GP 14. Disconnect the power cord from the
WARNING
10.
Figure 1.
3
Lift the bracket
housing.
3. Remove tray 5 feed sensor,
Figure 2 Feed sensor removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
the screws.
2. Make sure that the spring on the paper feed assembly is in the correct position,
May 2013
4-144
Figure 2.
2
Press the tabs to
release the sensor.
Place the spring
under the post.
Figure 3 Spring position
Xerox® WorkCentre® 5790 Family
GP 6 before refitting
Figure 3.