Rep 11.100-171 Ejector Paddle Assembly (W/Tag V-007) - Xerox WorkCentre 5790 Series Service Manual

REP 11.100-171 Ejector Paddle Assembly (W/TAG V-007)

Parts List on PL 11.140
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Rotate the ejector paddle assembly until the two short tabs are visible.
2. Remove the ejector paddle assembly,
1
Squeeze the two short tabs
together and pull to remove
the ejector paddle assembly
Figure 1 Ejector paddle assembly
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord
WARNING
Figure 1.
Replacement
1. Rotate the paddle shaft to ensure that the locating tab is uppermost,
2. Hold the paddle assembly by the two short tabs and clip onto the shaft.
NOTE: Ensure that the paddle assembly is correctly oriented to fit onto the plastic locat-
ing tab.
Figure 2 Paddle locating tab
May 2013
4-403
Figure 2.
Paddle locating tab
Repairs/Adjustments
REP 11.100-171