Rep 9.10 Auger Damper - Xerox WorkCentre 5790 Series Service Manual

REP 9.10 Auger Damper

Parts List on (35-55 ppm) PL 4.15, (65-90 ppm)
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Cam off the developer module.
2. Remove the xerographic module, PL 9.20 Item
3. Remove the waste toner from the auger system at the front of the machine,
Figure 1 Auger system at the front
4. Remove the waste toner bottle assembly,
Xerox® WorkCentre® 5790 Family
PL 4.10
WARNING
GP 14. Disconnect the power cord
WARNING
2.
1
Vacuum clean the
auger system
REP 9.1.
5. Remove the waste toner from the shutter auger tube at the rear of the machine,
Figure 1.
6. Remove the ozone filter and the duct,
7. Remove the waste toner full sensor up to step 3,
May 2013
4-197
Place the vacuum cleaner hose over the waste toner tube
and push the shutter to the open position.
Figure 2 Shutter and waste toner auger
PL 9.25 Item 2.
REP 9.4.
Figure 2.
Repairs/Adjustments
REP 9.10