Rep 2.1 User Interface Assembly - Xerox WorkCentre 5790 Series Service Manual

REP 2.1 User Interface Assembly

Parts List on PL 2.10
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Figure 1 ESD Symbol
Ensure that E.S.D. procedures are observed during the removal and installation of the user
interface assembly.
1. Open the front door, PL 8.10 Item 10.
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord from the
CAUTION
2. Remove the user interface assembly,
1
Remove 2 screws.
Figure 2 UI assembly removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
screws are installed.
2. If prompted, reload the software set,
downgrade when the machine is switched on,
May 2013
4-23
Figure 2.
2
Disconnect PJ905,
PJ130 and PJ81 then
carefully remove the
UI assembly.
GP 6
GP 4. The software will automatically upgrade or
GP 14.
Repairs/Adjustments
REP 2.1
before the