2
Remove 2 screws.
3
Disconnect the
motor harness and
remove the hole
punch motor
assembly.
4
Remove the screw securing the sensor bracket.
Disconnect the harnesses and remove the
bracket assembly. Press the tabs together to
remove the punch head home and punch head
present sensors.
Repairs/Adjustments
REP 11.7-110
5
Disconnect
the PJ.
Figure 1 Hole punch unit, motor and sensors
May 2013
4-242
6
Remove screw and slide out the bracket.
1
Remove the thumb
screw and slide out
the punch unit.
7
Remove 2 screws,
remove sensors
and disconnect the
harnesses.
Xerox® WorkCentre® 5790 Family