Rep 11.88-171 Left Hand Door Interlock Switch - Xerox WorkCentre 5790 Series Service Manual

REP 11.88-171 Left Hand Door Interlock Switch

Parts List on PL 11.175
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the inserter front and rear covers,
2. Remove the inserter motor, REP 11.84-171.
3. Remove the rear pivot screw and remove the top cover,
Repairs/Adjustments
REP 11.88-171
WARNING
GP 14. Disconnect the power cord
WARNING
REP 11.83-171.
Figure 1.
3
Remove 3 screws from
the rear.
5
Release the cable harness
clips and lift the top-inside
cover.
4. Remove the door latch pins then remove 4 screws holding the top inside cover,
5. Release the cable harness clips and lift the top-inside cover. Disconnect the PJs and
remove the top left door interlock switch.
Replacement
1. Reverse the removal procedures to replace the left hand cover interlock switch.
2. When reinstalling the inside top cover and the top cover make sure that the correct
screws are used and that the screws are not overtightened
May 2013
4-392
2
Remove 2 latch pins.
4
Remove 3 screws
from the front.
6
Remove the left hand
door interlock switch.
Figure 1 Switch removal
GP 6
Xerox® WorkCentre® 5790 Family
1
Remove the rear
pivot screw, then
the top cover.
Figure 1.