Xerox WorkCentre 5790 Series Service Manual page 346

11-024-110, 11-025-110 Paddle Roll Failure RAP
11-024-110 The paddle is not at the home position.
11-025-110 The paddle fails to rotate.
NOTE: The paddle is in the home position when the sensor flag is located between the sensor
jaws. If a jam occurs in the compiler, bin 1 will not be available.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Check the following:
• That there is no paper or other obstructions in the vicinity of the paddle.
• The paddle roll position sensor bracket is holding the sensor in the correct position, i.e.
the flag is in the middle of the sensor gap and the sensor does not touch any moving com-
ponents.
• Check that paper type is set correctly. If heavyweight paper is used but not set in the UI,
the compiler capacity can be exceeded. Refer to
and Non-stapled Sets RAP.
• Check the position of the paddles. With the paddle roll in the home position both sets of
paddles must be within the output cover, if they are not, refer to
Wheel Shaft Assembly. If any of the paddles are out of alignment to other paddles, install
a new paddle wheel shaft assembly,
• 2K LCSS PWB DIP switch settings, refer to
RAP.
Procedure
NOTE: All 2K LCSS interlocks must be made to supply +24V to the motors.
NOTE: In diagnostics, actuating any 2K LCSS sensor or switch can change the displayed state
on the UI. Make sure that the correct sensor or switch is tested.
Enter dC330, codes 11-024, paddle home position and 11-025, paddle run. The
rotates correctly.
Y N
Go to Flag 2. Check the paddle motor, MOT 11-024.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 10, How to Check a Motor.
• Figure 1.
• P/J310, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Paddle motor, PL 11.8 Item 10.
• 2K LCSS PWB, PL 11.26 Item 1.
A
Status Indicator RAPs
11-024-110, 11-025-110
11J-110 Mis-Registration in Stapled Sets
REP 11.12-110
PL 11.8 Item 4.
11F-110 2K LCSS PWB DIP Switch Settings
A
Enter dC330, code 11-025 and stack the code 11-326, to actuate the paddle roll position sen-
sor Q11-326. The display cycles high/low.
Y N
Go to Flag 1. Check Q11-326.
Refer to:
• 11G-110 2K LCSS PWB Damage RAP.
• GP 11, How to Check a Sensor.
• Figure 1.
• P/J314, 2K LCSS PWB.
• 11D-110 2K LCSS Power Distribution RAP
Repair or install new components as necessary:
• Paddle roll position sensor,
• 2K LCSS PWB, PL 11.26 Item
Perform SCP 6 Final Actions.
Paddle
paddle
Paddle motor
MOT11-024
May 2013
2-314
PL 11.8 Item 11.
1.
Figure 1 Component location
Xerox® WorkCentre® 5790 Family
Paddle roll
position sensor
Q11-326