Table of Contents
Advertisement
Table 21 Output codes 20
Code
Displayed Name
Description
20-132 V.34 33600 bps Line2
Emits V.34 33600 bps on line 2
General Procedures/Information
dC330, dC604
dC604 Registration Setup Procedure
General
Description
On/off
The registration setup routine allows the measurement and adjustment of image to paper reg-
istration for the image output terminal.
NOTE:
ADJ 8.1
Registration Setup contains only a reference to this diagnostic procedure.
Purpose
To measure and adjust image to paper registration using the four routines:
1.
Image Output Terminal Registration side 1 - simplex lead and top edge registration adjust-
ment.
2.
Image Output Terminal Registration Side 2 (duplex) - duplex lead and top edge registra-
tion adjustment.
3.
Scanner Registration - document glass lead and top edge registration adjustment.
4.
DADH Registration - constant velocity transport (CVT) lead edge and centre registration
adjustment.
NOTE: During the scanner and the DADH registration procedures a border erase is
applied to the copied test patterns. Since the test pattern has been designed for both mar-
kets regions, the size of the edge deletion will depend on the paper size:
•
For A4 LEF paper, all edges have a 10mm deletion, but the bottom edge (Zone C on
Figure
1) will measure 28mm from the edge of the paper.
•
For 8.5 x 11 LEF paper, all edges have a 10mm deletion, but the trail edge (Zone B
on
Figure
1) will measure 16mm from the edge of the paper.
Initial Action
•
Ensure that 8.5 x 11 or A4 LEF paper is loaded in tray 1.
•
Ensure that the ROS is secured and positioned correctly. Check that the ROS securing
screw at the front of the machine is present and secure, refer to
Procedure
NOTE: Always perform the IOT Registration Side 1 adjustments before performing any other
registration adjustment, as the IOT Registration Side 1 adjustment affects the others.
1.
Enter diagnostics,
GP
2.
Select, Diagnostics Routines, then select Copier Routines, then select
tion Setup Routine.
3.
Select Image Output Terminal Registration Side 1, then select All Trays, then select Print
Test Samples and follow the UI screen prompts.
NOTE: Do not select individual trays unless directed by the documentation.
a.
Compare the zones A and D on the test samples, with those in
b.
Adjust the registration, enter the number on the scale at the edge of the paper.
For example. If the top edge of the paper aligns with the 20mm mark on zone A (20
mm indicates correct IOT registration,
aligned with the 15mm mark then enter 15mm.
4.
Select Image Output Terminal Registration Side 2, then select All Trays, then select Print
Test Samples and follow the UI screen prompts.
May 2013
6-122
1.
Figure
2) then enter 20mm. If the top edge
Xerox® WorkCentre® 5790 Family
REP
6.1.
dC604
Registra-
Figure
2.
Advertisement
Chapters
Table of Contents
