Central Location Cabling (Phase 2); Ed -1E434, Group 133 Cable; Figure 31. Ed-1E434, Group 133 Cable; Table M. Ed-1E434, Group 133 Cable Connections (Phase 2) - AT&T System 85 Installation And Test

Central Location Cabling (Phase 2)
ED -1E434, Group 133 Cable
Install the ED-1E434, Group 133 (Figure 31) intracabinet cable(s) in the TMS/RMI cabinet(s)
that is equipped with an RMI carrier, as shown in Table M. These cables connect from the
remote module carrier backplane pins E06 to the inside of the rear connector REM DO on
the plates (845416585) added as described in the "Cable Connector Plates" section.
TABLE M. ED-1E434, Group 133 Cable Connections (Phase 2)
ORIGINATION CONNECTOR DESTINATION CONNECTOR
RMI
Carrier
Backplane
(Position 00)*
E06
•ia/II
Carrier (00)
Connector
Plate
REM
DO
RMI
Carrier
Backplane
(Position 01) .
E06 RMI
Carrier (01)
Connector
Plate
REM
DO
RMI
Carrier
Backplane
(Position 02)*
E06 RMI
Carrier (02)
Connector
Plate
REM
DO
RMI
Carrier
Backplane
(Position 03)*
E06 RMI
Carrier (03)
Connector
Plate
REM
DO
* Used only if RMI carrier is equipped in that position.
, KS
-23008,
L4
28 INCHES
252A CABLE
6 PAIR, 24 GAUGE
Figure 31. ED
-1E434,
Group 133 Cable
606
AMP 1-102935-5
COVER 103058-8
cnvER
103056-8
Page 45