TABLE BH..Power Switch S2
SETTING
POWER SOURCE
SPAN
60 or 140 mA span
current
BATT
—48 V dc
TABLE BI. Loopback Switch S3
SETTING
OPTION
LPBK
Loopback operation
NORM
Normal operation
TABLE BJ. Loop -Up Timing Switch S5
SETTING
OPTION
5 sec
5 second loop -up
detect interval
10 sec 10 second loop-up
detect interval
TABLE BK. Fault Locate Switch S6
SETTING
OPTION
OPEN
With fault locate
filter
CLOSED
Without fault locate
filter
Connections
All of the connections should be wire wrapped to a 56-pin connector at the rear of the shelf.
This is true for the rack-mounted shelf and the smaller wall-mounted unit used at the
remote location.
A block diagram of the Remote Group Interface using the Looping Office Repeater is shown
in Figure 108.
Page 157