Remote Location Rear Connector Plate (Emergency Transfer); Figure 14. Rear Connector Plate (845417229) And Location (Phases 1 And 2) - AT&T System 85 Installation And Test

Remote Location Rear Connector Plate (Emergency Transfer)
If the new system has the option Remote Emergency Transfer, replace existing plate
(844172429) at the rear of the remote module control cabinet(s) with connector plate(s)
845417229 in the location shown in Figure 14. The connector plate(s) is required for Phase 1
and Phase 2 systems.
Note: The 845417229 plate mounts only on R2 cabinet frames. If this is a retrofit R1
frame, use a standard R1 connector plate that will accommodate at least one Amphenol
connector. It will be necessary to loosen several connector plates to remove the blank
plate and install the new one. All plates should be secured to the cabinet after the new
plate is in place.
REMOTE MODULE
CONTROL CABINET
(REAR VIEW)
REM
EM XFR
DO
REAR CONNECTOR
BRACKET (845417229)
Figure 14. Rear Connector Plate (845417229) and Location (Phases 1 and 2)
Page 21