Samsung DVM PLUS III Technical Data Book page 736
Hide thumbs
Also See for DVM PLUS III:
- Technical data book (64 pages) ,
- Installation manual (54 pages)
Table of Contents
Advertisement
06_Installation(02~45)
3/15/08 4:34
Installation
1
DVM PLUS III, DVM PLUS III HR
1
1-9. Error codes
No.
Error code
71
E-407
72
E-410
73
E-413
74
E-416
75
E-425
76
E-428
77
E-431
78
E-438
79
E-440
80
E-442
81
E-443
82
E-452
83
E-453
84
E-454
85
E-455
86
E-457
87
E-458
88
E-461
89
E-477
90
E-559
91
E-560
92
E-561
93
E-562
94
E-563
95
E-601
96
E-602
97
E-603
98
E-604
99
E-605
100
E-606
101
E-607
102
E-608
103
E-609
104
E-610
105
E-611
106
E-613
107
E-614
108
E-615
109
E-616
110
E-618
111
E-619
112
E-620
113
E-621
114
E-652
115
E-653
116
E-654
117
P-701
118
P-702
119
P-703
VI-34
Page 34
Compressor stop by high pressure's protection control.
Compressor stop by low pressure's protection control.
Protection control by sump sensor.
Compressor stop by discharge temperature's protection control.
Reverse phase or phase open. (3ø Wiring of outdoor unit, R-S-T-N)
Compressor stop by abnormal compression ratio.
Self-diagnosis of oil solenoid valve. (Open and Close error)
EVI EEV opening error.
Prohibition of heating operation when the ambient air temperature is over 30˚C
Prohibition of refrigerant charging with heating operation when outdoor ambient air temperature is over 15˚C.
Prohibition of operating when the high pressure of system is too low.
Power failure temporarily or zero crossing error.
Overload error of outdoor unit's motor (by temperature).
RPM error of outdoor unit's motor
IPM overload error of outdoor unit's motor (by temperature)
Backlash error of outdoor unit's motor
Over current of CT sensor. (Or outdoor's motor locking of inverter system.)
Low current of CT sensor. (Or compressor starting failure of inverter system.)
Liquid refrigerant incoming protection error in digital / 1st fixed scroll compressor with sump temperature sensor.
Indoor unit stop by unidentified error from outdoor units.
Option switch setting error of outdoor unit. (napplicable option switch turns on.)
Fan RPM error of ERV SA (Supply air).
Fan RPM error of ERV RA (Return air).
Model mismatching of Indoor unit.
Communication error between remote controller and indoor unit.
Communication error between master and slave wired remote controller.
Communication packet error (Baud rate error)
Tracking failure error between wired remote controller and indoor unit.
Communication error. (7-day scheduler
COM1/COM2 communication setting error. (Wired remote controller)
Two masters of wired remote controllers were installed in one COM2 communication line.
Can't detect ERV controller.
Indoor unit is not detected for synchronous control.
Communication error between centralized controller and interface module.
Communication error between DMS and centralized controller.
Communication error between DMS and SIM interface module.
Communication error between SIM and power meter.
Communication error between interface module and indoor unit.
Communication error between interface module and outdoor unit.
The connected indoor units to ERV exceeded 16 units.
Mixed temperature display setting of indoor units which was connected to MWR-WS00 (Celsius/Fahrenheit)
Temperature display setting error of MWR-WS00 (Celsius/Fahrenheit)
Option switch setting error of wired remote controller (Master / Slave)
Two wired remote controllers were set to the master mode. (COM 1 wiring)
Room temperature sensor in the wired remote controller. (Open or Short)
Memory data error in the wired remote controller. (MWR-WS00)
Floating switch error of indoor unit. (1
st
EEV closing error of indoor unit. (1
detection)
st
EEV opening error of indoor unit. (1
Description
↔
Wired remote controller or 7-day scheduler
st
detection)
detection)
↔
Centralized controller)
Hide quick links:
Advertisement
Table of Contents
